| |
Special Production Request
Required for Ordering
Please do not hesitate to contact us for any support
issues. This trainer range is now discontinued and
only available on special production request.
Please see our newer product range
for alternate. This range is based on linear power
supply and single sided board with reverse side
jumpers |
|
 |
- Fixed DC
power supplies of ± 5V and ±
12V.
- Eight logic
switches with digital I/O
sockets and corresponding status
LEDs.
- A 100KO
potentiometer.
- Two
electronic relays.
- Logic probe,
speaker and buzzer.
- 555 Timer
with option to vary high and low
time of the waveform.
- 8-bit
analogue-to-digital converter
and digital-to-analogue
converter.
- Temperature
Sensor that reads temperature in
degrees Kelvin with scale of
10mV/ºK.
- A 4 rows x 3
columns push button key pad with
an associated 40 connections
female socket for interfacing it
with a telephone handset and
line.
- Four seven
segment displays with BCD
decoder.
- A push-to-ON
switch to generate a momentary
L-->H pulse.
- RS-232C
serial port interface.
- A 25 pin male
jack for connecting to the
parallel port of a PC and an
associated socket for
interfacing its input and output
to connections on the trainer.
- INSTEP
(Interactive Self Training &
Experimentation Package)
software.
- A breadboard.
- Accessories
include power cord, serial
cable, parallel cable, data bus,
circuit patching wire, dust
cover and user manual.
- High impact
ABS molded case of dimensions 9
cm H x 34 cm W x 36 cm D.
|
|
|
|
 |
